SMA STP 50-40 - Searching for and Installing New Firmware Via the User Interface

8 Operation
SMA Solar Technology AG
Operating manualSTP50-4x-BE-en-2390
9. Open the user interface and check the events to see whether the firmware update has been
completed successfully.
10. If the firmware update has not been successfully completed, perform the firmware update
again.
8.28.4 Searching for and Installing New Firmware via the User
Interface
Requirement:
☐ The inverter must be connected to the Internet.
Procedure:
1. Open the user interface (see Section8.2, page61).
2. Log into the user interface as an Installer (see Section8.3, page65).
3. Select the menu Device Parameters.
4. Click on [Edit parameters].
5. Go to Device > Update.
6. Select the parameter Check for update and install it and set it to Execute.
7. Click on [Save all].
☑ The firmware is updated in the background.