Operating Manual SB3-5TL-21-BE-en-10 33
SMA Solar Technology AG 7 Initial Start-Up
7Initial Start-Up
7.1 Procedure
Einl.Satz_Vorgehensw eise
Before you commission the inverter, you must check various settings and make changes if necessary.
This section describes the procedure for initial start-up and provides an overview of the steps that must
always be performed in the given sequence.
7.2 Configuring the Country Data Set
A display language is assigned to every country data set. Configure the country data set with the
associated display language so it is appropriate for your country or purpose. If the display language does
not match the required language, you can change it after commissioning (see Section 8.2, page 41).
The country d ata set must be s et correctly.
1. Determine the rotary switch position for your country and purpose. Call up the Technical
Information "Overview of Rotary Switch Positions" at www.SMA-Solar.com.
Procedure See
1. Check which country data set the inverter is set to. Supplementary sheet with
the default settings, type
label or display
2. If the country data set is not set correctly for your country or
your purpose, adjust to the required country data set and
corresponding display language.
Section 7.2, page 33
3. If the inverter is to communicate with multiple Bluetooth
devices or if Bluetooth is not to be used as the type of
communication, adjust the NetID.
Section 7.3, page 34
4. Commission the inverter and start a self-test, if required. Section 7.4, page 36 and
Section 7.5, page 37
The country data set must be set correctly.
If you configure a country data set that is not valid for your country or purpose, it can cause
a disturbance in the PV system and lead to problems with the grid operator. When selecting
the country data set, you must always observe the locally applicable standards and directives
as well as the properties of the PV system (e.g. PV system size, grid-connection point).
• If you are not sure which country data set is valid for your country or purpose,
contact your grid operator and ask which country data set should be configured.
48$/,),('3(5621
48$/,),('3(5621
To Next Page
Loading...
