Operating Manual SB3-5TL-21-BE-en-10 41
SMA Solar Technology AG 8 Configuration
8.2 Changing the Display Language
If the language associated with the country data set is not your desired language, you can change
the display language according to the following procedure.
2. Determine the rotary switch setting for the desired display language. Call up the Technical
Information "Overview of Rotary Switch Positions" at www.SMA-Solar.com.
4. Set the rotary switch B to the required language using a flat-blade screwdriver
(blade width: 2.5 mm).
5. Recommission the inverter (see Section 11, page 49).
☑ The inverter adopts the settings after commissioning. This can take up to five minutes.
1.
Danger to life due to high voltages
• Disconnect the inverter from all voltage sources and open the enclosure lid
(see Section 10, page 47).
3. Set rotary switch A to 0 using a flat-blade
screwdriver (blade width: 2.5 mm). This ensures
that the country data set remains unchanged.
48$/,),('3(5621
To Next Page
Loading...
