SMA SUNNY TRIPOWER CORE1-US - Logging In and Out of User Interface

5 Mounting
SMA Solar Technology America LLC
Installation ManualSTP50-US-40-IA-en_es-1122
Procedure:
1. Tighten every foot with two M8x40 hexagon screws
and two washers on the two external taps (M8x14)
on the underside of the inverter (torque: 16Nm
(142in-lb)).
4x
A
_
+
_
+
B
C
D
E
F
2. Screw all four transport handles as far as they will
go into the taps on the right- and left-hand side until
they lie flush with the enclosure. When doing so,
ensure that the transport handles are screwed into
the taps so that they are perfectly straight. If the
transport handles are not screwed in straight, this
can make it more difficult or even impossible to
unscrew them later on and can damage the taps to
the extent that transport handles can no longer be
screwed into them.
A
_
+
_
+
B
C
D
E
F
4x4x
3. Insert a screwdriver into the holes in the transport
handle and turn the screwdriver through 90°. This
ensures that the transport handles are securely
tightened.
90°
4x
4. Remove the inverter from the Euro pallet and
position the inverter at the installation location.
3
1
2
A
_
+
_
+
B
C
D
E
F
5. Make sure that the inverter is stable.
6. Remove all four transport handles from the taps. If necessary, insert a screwdriver into the
holes on the transport handle and use the screwdriver to remove the transport handle.
ENGLISH