SMA SUNNY TRIPOWER CORE1-US - Displaying and Downloading the Stored Data

4 Using the Inverter User Interface
SMA Solar Technology America LLC
User ManualSTP50-US-40-BA-en-1028
Layout of the installation assistant
A
C
B
Figure 3: Layout of the installation assistant (example)
Position Designation Description
A Configuration steps Overview of the installation assistant steps. The number of
steps depends on the type of device and the additionally
installed modules. The current step is highlighted in blue.
B User information Information about the current configuration step and the
setting options of the configuration step.
C Configuration field You can make settings in this field.
Requirement:
☐ When configuring after completion of the first tenfeed-in hours or after exiting the installation
assistant, the SMA Grid Guard code must be available in order to change the grid-relevant
parameters (see "Application for SMAGridGuard Code" at www.SMA-Solar.com). A charge
is levied for this code.
Procedure:
1. Activate the user interface (see Section4.1, page19).
2. Log in as Installer.
3. Select the menu User Settings (see Section4.3, page24) on the start page of the user
interface.
4. In the context menu, select [Start the installation assistant].
☑ The installation assistant will open.
4.5 Displaying and Downloading the Stored Data
If an external storage device is plugged in, you can display and download the stored data.