SMA SUNNY TRIPOWER CORE1-US - Saving the Configuration in a File; Adopting a Configuration from a File

5 Configuration of the Inverter
SMA Solar Technology America LLC
User ManualSTP50-US-40-BA-en-1034
3. On the right-hand side of the menu bar, select the menu User Settings (see Section4.3 "Start
Page Design of the User Interface", page24).
4. In the context menu, select [Starting the installation assistant].
5. Select [Save and next] until you reach the String configuration step.
6. Activate string-failure detection and configure it as required.
5.8 Saving the Configuration in a File
You can save the current configuration of the inverter in a file. You can use this file as a data
backup for this inverter and then import this file into this inverter again or another inverter from the
same type or device family to configure the inverter. When saving, only the device parameters will
be saved, not any passwords.
Procedure:
1. Activate the user interface (see Section4.1, page19).
2. Log into the user interface (see Section4.2, page22).
3. Select the menu Device Configuration.
4. Select [Settings].
5. In the context menu, select [Saving the configuration in a file].
6. Follow the instructions in the dialog.
5.9 Adopting a Configuration from a File
To configure the inverter, you can adopt the configuration from a file. To be able to do this, you
must first save the configuration of another inverter from the same type or device family in a file (see
Section5.8 "Saving the Configuration in a File", page34). When saving, only the device
parameters will be adopted, not any passwords.
Requirements:
☐ The SMA Grid Guard code must be available (see "Application for SMAGridGuard Code"
at www.SMA-Solar.com). A charge is levied for this code.
☐ Changes to grid-relevant parameters must be approved by the responsible grid operator.
Procedure:
1. Activate the user interface (see Section4.1, page19).
2. Log into the user interface as an Installer.
3. Select the menu Device Configuration.
4. Select [Settings].
5. In the context menu, select [Adopting the configuration from a file].
6. Follow the instructions in the dialog.