SMA WINDY BOY 3300 - Page 32

Electrical Connection SMA Solar Technology AG
32 WB33-38-IA-IEN120940 Installation Manual
3. Ensure that the cable is correctly positioned:
4. Push the cable gland up to the thread and fasten to a torque of 2 Nm.
☑ The DC connectors are now assembled and can be connected to the inverter as described in
Section 5.5.4"Connecting the Small Wind Turbine System (DC)" (page34).
Result What to do
☑ If the stranded wire is visible in the chamber
of the clamping bracket, the cable is
correctly positioned.
• Proceed to step 4.
☑ If the stranded wire is not visible in the
chamber, the cable is not correctly
positioned.
•
Release the clamping bracket. Do this by
inserting a screwdriver (blade width: 3.5 mm)
into the clamping bracket to lever it open
.
• Remove the cable and go back to step 1.