SMA Solar Technology AG Electrical Connection
Installation Manual WB33-38-IA-IEN120940 31
5.5.2 Assembling the DC Connectors
For connection to the inverter, all connection cables of the small wind turbine system must be fitted
with the supplied DC connectors.
Assemble the DC connectors as follows. Ensure the connectors have the correct polarity.
The DC connectors are marked with the symbols "+" and " − ".
Cable requirements
• Use a PV1-F cable.
Procedure
1. Insert the stripped cable into the plug up to the stop.
2. Press the clamping bracket down until it audibly
snaps into place.
To Next Page
Loading...
