SMART Board 8070i - Cleaning the Camera Windows and Reflective Tape; Cleaning the Screen

g To replace a pen nib
1. Grasp the worn nib on your pen with a pair of pliers, and then pull and twist the nib loose.
2. Press the replacement nib into the pen.
Cleaning the screen
Follow these instructions to clean the interactive display screen without damaging its anti-
reflective coating or other product components.
C  C A U T I O N
l Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used
on the screen, remove the ink as soon as possible with a lint-free, non-abrasive cloth.
l Do not rub the screen with a dense or rough material.
l Do not apply pressure to the screen.
l Do not use cleaning solution or glass cleaner on the interactive display screen, as they
can deteriorate or discolor the screen.
l Avoid touching the silver reflective tape between the screen and the bezel and ensure
that it stays dry. Damage to this strip affects touch interactivity.
g To clean the LCD screen
1. Shut off your computer, and then disconnect the power sources for your computer and your
interactive display.
2. Wipe the screen with a lint-free, non-abrasive cloth.
Cleaning the camera windows and reflective
tape
The DViT technology in your display uses four cameras in the corners of the display and the
reflective material between the screen and the bezels. Excessive dust buildup on the camera
windows or reflective tape can impair touch performance.
These areas should be inspected annually for dust and should be cleaned if any obvious dust
buildup has occurred.
C H A P T E R 7
Maintaining your interactive display
63