USER MANUAL
10
VII. RESET AND RESTORE FACTORY SETTINGS
To restore the factory settings, you must use the Reset button.
The Reset button is located near the top group of contacts. The
Reset button has two functions:
1. Reboot the device - briefly press the Reset button. After
pressing the Reset button, the device will reboot and enter the
wireless access point mode.
2. Restoring factory settings - press and hold the Reset button
for more than 5 seconds. After restoring factory settings,
the device will reboot and enter wireless access point mode.
Connect to your wireless network and configure the machine
according to Chapter 3 “Connecting to a wireless network” and
“Configuring settings”.
Factory reset does not affect energy storage meters.
The wireless access point mode will turn off automatically 15
minutes after the end of work with the WEB interface of the device.
The device does not require periodic maintenance.
A built-in CR 2032 3V battery is used to power the device clock.
The battery installed in the device has a long service life - more
than 10 years. Battery life is greatly influenced by the temperature
conditions in which the device is used.
In the event of a complete battery failure, the device will continue
to operate with limited functionality.
Replacing the battery is carried out in the following sequence:
1. Disconnect the device from the power supply.
2. Unscrew the 4 screws connecting the device body
and remove the upper case.
3. Remove the old battery from the holder.
4. Observing the polarity, insert a new battery into the holder.
5. Put on the upper part of the case and tighten the 4 screws.
VIII. MAINTENANCE OF THE DEVICE
To Next Page
Loading...
Need help?
General