RESIDENTIAL 5-2 DAY PROGRAMMING MODE
7
Mode selection
The 44-800 can control both heating and cooling. Touch the Mode box to cycle through and
select available modes. Based on equipment and thermostat configuration, mode selection
can be as follows:
Off - Thermostat will not call for heating
or cooling.
Heat - Thermostat only controls heating.
When heating system is running, Heat
flashes.
Cool - Thermostat only controls cooling.
When cooling system is running, Cool
flashes.
Auto - Thermostat controls both heating
and cooling. Heat or Cool will flash when
equipment is running.
E. Heat - Emergency heat for heat pump
systems should the compressor fail.
Heat
Heat Set
PM
Day
E
To Next Page
Loading...
