Adjusting the volume
X
To raise the volume: turn the control
knob clockwise.
X
To lower the volume: turn the control
knob anti-clockwise.
Boosting volume for traffic announce-
ments
Audio system basic plays traffic announce-
ments at an increased volume. The playback
volume is set at the factory and cannot be
adjusted.
Mute
When in radio mode, the mute function
mutes the radio.
If a traffic announcement is broadcast
while the radio is muted, the announcement
will still be audible.
To mute the traffic announcement, the
x button must be pressed again.
Pressing and holding switches the TA (traf-
fic announcement) function on or off.
Switching mute on
X
Press the x button.
The currently active operating mode is
muted.
x appears in the display.
Switching off mute
X
Press x again.
The mute function is deactivated. The
corresponding symbol in the display
goes out.
Sound settings
The sound settings can be set separately for
the radio and USB modes. In AUX mode, the
same sound settings are used as in USB
mode, however you can make additional set-
tings on the external device. The sound
settings are automatically stored every
time you change them. The bass and treble
settings allow you to adjust the intensity
of the sound according to the type of music
being played. The balance settings allow
you to adjust the stereo sound to the left or
right within the vehicle. In the default
setting, the balance is set to the centre of
the vehicle.
Setting the bass
X
Press the u button.
X
Press the : button repeatedly until
Bass is selected.
X
To set the desired value: press the =
or ; button to decrease or increase
the value.
X
To confirm the value and exit the menu:
press the 9 or % or u button.
Setting the treble
X
Press the u button.
X
Press the : button repeatedly until
Treble is selected.
Basic functions
9
>> At a glance.
Z
To Next Page
Loading...
Need help?
General
