C H A P T E R 7
Troubleshooting your projector
63 smarttech.com/kb/170295
Determining curtain alignment tool (CAT) status
The CAT has one status light. If you’re experiencing issues with the CAT, press the front side of the
CAT against the surface and ensure that the status light is green. See the LightRaise interactive
projectors installation guide (smarttech.com/kb/170259) for more information.
Use the table below to determine the status of the CAT.
CAT
status
light
Status and related troubleshooting
Solid
green
The CAT is on, in contact with the surface and ready to use.
Off The CAT is turned off. Turn the switch to the On position.
Off The battery needs to be replaced (see Replacing the CAT battery on page 47).
Off Your surface isn’t flat enough to activate the CAT (see Choosing a surface on page 7).
Determining XCP status
The XCP has one projector status light and two active input lights.
Projector status light
The XCP Power button illuminates to indicate the projector status and provides the same status
information as the Power button on the projector.
See Determining projector status on page 60 for more information on the Power status light.
Active input status lights
The XCP has two input status lights. The status light is illuminated next to the active input.
To Next Page
Loading...
