HGM6100N Series Genset Controller User Manual Page 12 of 47
speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during genset running, controller can protect genset to stop (detail procedures please refer to
No.4~9 of Auto start operation). Under Manual Mode, switch won’t transfer automatically, it is
necessary to press to transfer load.
2) HGM6110: Manual Mode is active when pressing , and its indicator is illuminating. Then
press to start genset, it can automatically detect crank disconnect and accelerate to high
speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during running, controller can protect genset to stop quickly (detail procedures please refer to
No.4~9 of Auto start operation). After genset runs well in high speed, press and gens takes
load.
3) Manual Stop: Pressing can shut down the running genset (detail procedures please refer to
No.3~7 of Auto stop operation).
4.5 EMERGENCY START
In manual mode, pressing and simultaneously can compel genset to start. The controller
won’t judge whether the controller has started successfully according to disconnect conditions and the
disconnection of starter needs to be controlled by operators. When operators observed the genset has
started successfully, loose the keys and the controller enters safety delay with start no outputting.
5 PROTECTION
5.1 WARNINGS
When controller detects the warning signal, the genset only sends alarm and not stops. The alarms
are displayed in LCD.
Table 4 – Controller Warning Alarms
To Next Page
Loading...
