31
In this menu you can:
● [Region] press the Vol- / Vol + keys to select the country where the device will be
used. This choice is critical because it will provide the decoder with the information
for a correct reception of the channels.
● [Language] press the Vol- / Vol + buttons to select the language used by the device.
● [Display Mode] press the Vol- / Vol + buttons to select the video resolution used by
the device. The device will start in 576p in Scart or 720p@50Hz in HDMI. We
recommend that you select 1080p_50 for FULL HD televisions or 720p_50 for HD
TVs.
● [Aspect Mode] select Auto.
● [Antenna Power] select the option On to supply the signal on the antenna output.
Highlight the word OK in the OSD and then click the OK button on the remote control.
Automatic channel tuning will start immediately. This process is completely automatic
but can last several minutes. After tuning, you can watch TV.
In the lower part, in menu mode, there is a legend with the active
keys on the displayed page.
● Use the [arrows Vol- / Vol + and CH + / CH-] to move
through the menus and change their settings.
● Tap on thebutton OK to confirm the selection.
● Tap Exit to exit.
1.6 Recording
Before the recording / PVR / TimeShift function can be used, a USB memory (already
formatted) must be connected to the USB port of the device. See the following figure.
Format the key now. Press Menu, then select the option Media Player. Select the
option PVR Storage Information in order to check the free size.
To Next Page
Loading...