SmartPay Pax D210 - Setting Static IP Address

14
MERCHANT & COMMUNICATION SETTINGS
SETTING STATIC IP ADDRESS
The terminal will default to a DHCP IP address. To change this to a Static IP follow the steps below or
contact our THD to assist you.
To use a Static IP address your network must either have a section of addresses reserved for this
purpose (this is usually congured in your router - if you are unsure please consult your ISP or IT network
administrator).
Alternatively assuming there are only a few devices connecting on your network, you can select a high
number in the DHCP range* (this is to reduce likelihood of IP conict issues).
* Smartpay is not an IT provider and does not take any responsibility for managing your network conguration.
• Press MENU > QUICK ACCESS MENU > COMMS
Wi-Fi SETTING:
SSID : Networkname1234
Sec mode: WPA2PSK
ENTER = OK CLEAR = CHANGE
TERMINAL COMMS
WIFI
BLUETOOTH
TERMINAL
ADDRESS ALLOCATION
CURRENTLY
DHCP
CLEAR TO CHANGE
SCAN FOR AVAILABLE
Wi-Fi ACCESS POINTS?
ENTER: SCAN
CLEAR: MANUAL ENTRY
• Select WIFI
(Screen displays Wi-Fi network settings)
Screen displays current Wi-Fi network settings
• Press ENTER
• Press ENTER to start automatic scan
OR
• Press CLEAR if you want to congure manually
Wait while terminal scans for available Wi-Fi networks
Wait while terminal connects to chosen Wi-Fi network
• Press CLEAR to change to STATIC then press ENTER to
continue