WPS Method
If the device you wish to connect to the Internet via your gateway supports the WPS secure WiFi connection method,
follow these steps.
1. In the left navigation bar, click Wireless > the wireless band you want to configure, and then click Security.
2. In the Enable WPS field, select Enabled.
3. Click Apply/Save to commit your selection.
4. On the left side of the gateway, press the button labeled WPS.
l To activate the 2.4 GHz band, press the button for 1-3 seconds.
l To activate the 5 GHz band, press the button for 5-7 seconds.
5. Within 2 minutes, activate WPS on the 3rd party device to which you wish to connect. The device may have a
push button on its exterior that you can press, or a clickable button on a software interface. To learn how to use
the WPS feature on your client device, refer to its documentation.
Your device should now be connected to your gateway wirelessly using WPS. If you encounter problems with the WPS
setup such as connection failure, refer to your client device for further instructions.
9
To Next Page
Loading...
