9. Weather Station and Remote Sensor Pairing & Manual Signal Reception
— Insert 2 x AA batteries in the weather station and connect it with the adapter.
— Insert 2 x AA batteries in the remote sensor.
This mode is applicable if multiple wireless remote sensors are used simultaneously.
9.1 Weather Station and Remote Sensor Pairing
9.2 Outdoor Channel Cycle Mode
9.3 Manual Signal Reception
Step 1:
— Select a channel for the remote sensor through the numbered knob (1, 2, and 3).
The indicator will light up once to indicate that the wireless remote sensor is
sending out signals.
— Select the same channel with the remote sensor for the weather station. Press
" " button to select CH1, CH2, CH3 or CH1 to CH3 (cycle mode).
－ When the weather station successfully receives signals from the remote sensor,
the temperature and humidity detected by the remote sensor will display in the
"OUT" column of the weather station.
－ The weather station can connect up to 3 wireless remote sensors at the same
time. If multiple sensors are used simultaneously, please make sure these sensors
are on different channels and press " " button on the weather station to view the
readings of each channel.
－ Press " " button on the weather station until " " is displayed above the
outdoor channel. In this mode, the outdoor readings will display from CH1 to CH3
automatically every 5 seconds.
－ To make the temperature and humidity on a fixed channel, just press " "
button until " " disappears. Once it disappears, the outdoor readings will stop
cycling.
If there is no outdoor temperature displayed on the weather station, or there is no
change in the temperature and humidity for a long time, it indicates that the
weather station is failing to receive signals from the wireless remote sensor. Please
take the following actions:
Step 2:
9
To Next Page
Loading...