13. Air Pressure
14. Backlight & Night Mode
The barometric pressure updates every hour. The weather station will record the
pressure of the last 3, 6, 9, 12, 18, 24 hours and compare it with the current
barometric pressure to generate a histogram.
In night mode, the backlight will automatically dim at the set entry time.
● To set night mode, press and hold the " " for more than 2 seconds. "OFF"
(the state of the night mode) will be flashing, press "▲" or "▼" to turn on or off night
mode and press " " to confirm.
● The brightness level will be flashing, there will be 3 brightness levels for
selection, press "▲" or "▼" to select a level and press " " to confirm.
● The hour of the entry time of night mode will be flashing, press "▲" or "▼" to set
the required hour and press " " to confirm.
● The minute of the entry time of night mode will be flashing, press "▲" or "▼" to
set the required minute and press " " to confirm.
● The hour of the exit time of night mode will be flashing, press"▲" or "▼" to set the
required hour and press " " to confirm.
— When connecting the weather station with the DC adapter, the backlight will
remain on. The backlight has 5 brightness levels for selection: level 1, level 2, level 3,
level 4 and OFF. To adjust the backlight brightness, press " " to choose a
brightness that is comfortable for you.
— When the backlight brightness is not at the maximum brightness, touching
" " can make the backlight light up to the maximum brightness for 15 seconds.
— Any restart or power break will cause a loss of the previous manual settings. In
case of power failure, please insert 2 AA batteries in the weather station to protect
saved manual settings.
14
● The power of the batteries is not enough to support the dynamic lighting of the large
display. It is recommended to connect the weather station with the DC adapter.
● When the weather station is only powered by batteries, touching " " will
temporarily activate the backlight for 15 seconds, after which the screen will return to the
dimmest brightness level and enter power-saving mode.
Note:
14.1 Backlight Setting
14.2 Night Mode Setting
To Next Page
Loading...