6. Preparation
7. Initial Time Setup
● Open weather station battery compartment cover, insert 2 x AA batteries,
ensure correct battery polarities [ "+" and "–" ] and connect the DC adapter to
power the weather station.
● The screen will light up, and the device will make a beeping sound. The weather
station will start to detect indoor temperature and humidity.
● Open the wireless remote sensor battery compartment cover. Choose the same
channel as the weather station through the numbered knob. Insert 2 x AA batteries,
ensure correct battery polarities [ "+" and "–" ].
● The sensor will send out a red light which means that it’s sending signals to the
main unit.
● The weather station will start to make a connection with the outdoor remote
sensor, a reception RF antenna symbol in the "OUT" display area will flicker on the
screen. This procedure will take 3 minutes at most.
● After the unit has made a connection with the outdoor remote sensor, the
detected temperature and humidity will be displayed on the screen.
● Hold " " button for 2 seconds.
● The "OFF" indicates the status of button sound, it will be flashing. If changed to
"ON", a beep sound will be heard when pressing buttons on the device. Press "▲" or
"▼" to choose whether to have beep sounds on or off and press " " to confirm.
● The temperature unit "°F" will be flashing, press "▲" or "▼" to choose "°F" or "°C"
and press " " to confirm.
● The pressure unit "INHG" will be flashing, press "▲" or "▼" to choose "HPA" or
"INHG" and press " " to confirm.
● The daylight saving time (DST) function status "ON" will be flashing, press "▲" or
"▼" to choose the function on or off and press " " to confirm.
● The 12Hr will be flashing, press "▲" or "▼" to choose 12Hr or 24Hr format and
press " " to confirm.
● The HOUR will be flashing, press "▲" or "▼" to set the correct hour and press
" " to confirm.
● The MINUTE will be flashing, press "▲" or "▼" to set the correct minute and press
" " to confirm.
● The YEAR will be flashing, press "▲" or "▼" to set the correct year and press
" " to confirm.
● The MONTH will be flashing, press "▲" or "▼" to set the correct month and press
" " to confirm.
● The DATE will be flashing, press "▲" or "▼" to set the correct date and press
" " to confirm.
6
To Next Page
Loading...