Smartro SC93 - Sensor Pairing and Signal Reception; Pairing Weather Station and Sensor; Managing Multiple Remote Sensors; Manual Signal Reception

－ Please ensure that the channels of the weather station and sensor are the same.
－ Long press " " button to receive signals manually. A flashing RF antenna
symbol will be displayed beside the channel. This means that the weather station is
in a receiving state.
－ Press "TX" button on the wireless remote sensor to send out signals manually, a
red light will flash.
9.4 How to Check Maximum/Minimum Temperature/Humidity
● To toggle indoor/outdoor maximum, minimum temperature and humidity data,
please press "▼" :
Press once to show the maximum temperature and humidity values.
Press twice to show the minimum temperature and humidity values.
Press three times to return to the current temperature and humidity values.
● To reset the maximum and minimum temperature and humidity, hold "▼"
button for 2 seconds, dashes will be displayed on the screen and the recorded
history of indoor maximum and minimum temperature, humidity and outdoor
values of current channel will be cleared away. The weather station will start to
re-record the maximum/minimum values.
● To clear the maximum and minimum temperature and humidity of the other
channels, press " " button to switch channels and repeat the steps above.
10
● In the case of using only one sensor, when the channel of the weather station is not the
same as the channel of the sensor, there will be no outside temperature readings shown
on the weather station.
● The wireless sensor can be placed anywhere (indoor or outdoor) you want to measure
the temperature remotely.
● If you want to measure the outdoor temperature, place the sensor outside away from
direct sunlight and rain such as under a roof or on a porch.
● If the temperature or humidity reading is below the ranges, “LL.L” will appear. If the
temperature or humidity reading is above the ranges, “HH.H” will appear.
● Indoor temperature measurement range: +14°F (-9.9°C) ~ +122°F (+50°C)
● Outdoor temperature measurement range: -40°F (-40°C) ~ +158°F (+70°C)
● Indoor humidity measurement range: 20%RH~95%RH
Note: