-39-
EX※※-OMR1012
•Digital I/O unit parameters (2)
Parameter
setting
No. Parameter Definition Item Content
Default
setting
By
E.O.
By
W.S.
Enable
Generates an error.
Val: 1 to 65000
5
10
Input or
Output
ON/OFF
counter
Memorizes the
number of times
the input or output
device is ON.
Generates error
per channel when
the operation count
exceeds the set
value.
4
Disable
Does not generate an
error.
○
○ ○
11
Valve
ON/OFF
counter clear
Clears the valve
ON/OFF counter to
0. (Refer to page
77 for the clear
method).
-
- -
x
○
1: Could be incorrectly recognized as short circuit depending on used load (ex.: lamp load). If detection is incorrect, disable the
parameter setting.
2: This function is valid only when “Hold/Clear priority” of the system parameter is set to “Via software“.
3: Some PLC does not support an idle mode.
4: The count is memorized every hour. When the power supply is turned on again, counting starts from the last value memorized.
5: Times for setting is set value x1000 times.
To Next Page
Loading...
Need help?
General
