I
NSTALLING
THE
S
WITCH
6
Selecting a Site
Be sure to follow the site selection guidelines below when choosing a
location:
• Select a suitable location for the switch:
• It should be accessible for installing, cabling and maintaining the
switch.
• The temperature and humidity should be within the ranges listed in the
specifications.
• The status LEDs should be clearly visible.
• There should be adequate space (approximately two inches) on all sides
for proper air flow.
• Make sure twisted-pair cable is always routed away from power lines,
fluorescent lighting fixtures and other sources of electrical interference
such as radios, transmitters, etc.
• Make sure that a properly grounded power outlet is within 2.44 meters
(8 feet) of the switch and is powered from an independent circuit
breaker. As with any equipment, using a filter or surge suppressor is
recommended.
Instructions
1. Positioning the Switch: For desktop or shelf mounting, attach the
four adhesive feet to the bottom of the switch. For rack mounting,
install into a standard EIA 19-inch rack using the included brackets.
2. Applying Power: Plug one end of the power adapter into the socket
on the switch’s rear panel, and the other end into an appropriate
electrical outlet. Check the Power LED to be sure power is on.
Note: It is not necessary to power off the switch before connecting or
disconnecting any UTP cables, as these actions will not disrupt
the operation of other devices attached to the switch.
To Next Page
Loading...
Need help?
General
