EN - 13
EN
Cleaning and maintenance
“Empty system” procedure
The ‘Empty system’ procedure is recommended
before long periods of non-use and before
consulting a maintenance manager.
• Activate the procedure by holding down the
key (22) and the key (25) simultaneously
for three seconds, the key (23) and the key
(25) ash simultaneously.
• The entire quantity of water in the tank is
drained through the coffee circuit and the
steam spout.
• The pump continues to operate, even
intermittently, to also empty the internal
water circuits.
• At the end of the procedure the machine
switches off.
The empty system procedure takes
several minutes and on-off cycles.
Do not turn off the machine until the
complete procedure is complete.
To Next Page
Loading...
Need help?
General
