EN - 16
Problem Possible causes Solution
All buttons ash
simultaneously.
Hydraulic circuit error. Make sure there is water
in the tank and wait for the
circuit to reset. The machine
automatically returns to its
initial position. If the problem
persists, contact an authorised
service centre.
The machine does not
dispense steam.
The steam function was not
correctly turned on.
Follow the instructions
in paragraph “Steam
dispensing”.
The machine did not reach
the steam dispensing
temperature.
Wait until the temperature is
reached, indicated by steady
lit key 25.
Insufcient frothing.
The steam wand is dirty. Thoroughly clean the steam
wand removing the steel
nozzle and following the
instructions in the manual.
Note: froth quality also
depends on the type of milk
used.
Contact local technical support if the problem is not solved or in case of other types
of faults.
To Previous Page
Loading...
Need help?
General
