Smeg FC66B1 - Setting the Pyrolysis Cycle

67
Instructions for the user
9.6.2 Setting the cleaning cycle
Use PT2 to select one of the two pyrolysis
functions, either or .
To start the cleaning (Pyrolysis) cycle, press
PT1 twice; the symbol will start flashing;
turn knob PT1 to the left or right in order to increase or decrease the
duration of the cycle, from a minimum of 1h 30m to a maximum of 3h
00m. (Except for the function where the cycle duration is fixed at 1h
30m). A few seconds after selecting the desired duration the symbol
will remain lit.
The message “Pyro” will appear on DSP1 to indicate that the oven is
performing the cleaning cycle. One minute after the cleaning cycle
(Pyrolysis) starts, an interlock device which prevents opening of the door
will be tripped.
The symbol lights up on DSP1 to indicate that this interlock device has
been activated.
To select a delayed cleaning cycle you first
need to set the duration of the pyrolysis. Then
press PT1 once: the symbol will start
flashing and the current time will be displayed
on DSP.
Turning PT1 to the right increases the time and the time at which you
wish the pyrolysis to finish can be selected.
A few seconds after the last action on PT1 the and symbols will
remain lit, and the oven will start to wait for the starting time set.
It is not possible to select any functions once the door interlock has been
activated. Wait for the indicator to switch off.