68
Instructions for the user
10. EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts
subject to wear such as seals, bulbs, and so on. The following instructions
describe how to carry out these minor maintenance operations.
Before any intervention that requires access to live parts, disconnect the
power supply of the appliance.
10.1 Changing the light bulb
Remove the bulb protector A by
turning anticlockwise and
replace bulb B with a similar
one (25 W). Re-fit the bulb
protector A.
Use only oven bulbs (T 500°C) (only for pyrolytic models).
Use only oven bulbs (T 300°C) (only for multifunction models).
10.2 Removing the door
10.2.1 With moveable levers
With the door completely
open, lift the levers A of
the two hinges until they
touch the hinges B and
take hold of the two sides
of the door with both
hands close to the hinges
themselves.
Raise the door to an angle of about 45° and remove it. If the hinges have
not locked, repeat the operation, raising the levers A and keeping the door
slightly raised. To reassemble, fit the hinges B into their grooves, then
lower the door into place, ensuring that it remains fitted into the grooves C,
then lower the levers A.
To Next Page
Loading...
Need help?
General
