35
Instructions for the installer
2. INSTALLATION
2.1 Electrical connection
Make sure that the voltage and capacity of the power supply line
conform to the data shown on the plate located on the oven door frame.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a plug and socket connection is being used make sure that the plug
and socket are compatible. Avoid use of adapters and shunts as these
could cause overheating and burns.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than 3
mm, in an easily accessible position close to the appliance.
For operation on 220-240V
∼
: use a
H05RR-F / H05RN-F type three-core cable
(3 x 1.5 mm
2
).
The end to be connected to the appliance
must be an earth wire (yellow-green) at
least 20 mm longer.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
To Next Page
Loading...
Need help?
General
