6
select 'Manual tune', and then press Enter button to confirm.
2. Press Tune – or Tune + button to select the frequency you desire, and then press
Enter button to confirm.
DRC (Dynamic Range Control) value
You can set the compression level of stations to eliminate the differences in dynamic
range or sound level between radio stations.
1. Press Info/menu button, press Tune – or Tune + button to select 'DRC', and then
press Enter button to confirm.
2. Press Tune – or Tune + button to select through 'DRC high', 'DRC low' or 'DRC off',
press OK button to confirm.
Prune
You may remove all unavailable stations from the station list.
1.
Press and hold Info/menu button, press Tune – or Tune + button to select
'Prune', and then press Enter button to confirm.
2.
Press Tune – or Tune + button to select ‘YES’, and then press Enter button
to confirm.
Viewing Station Information
DAB/DAB+ stations broadcast additional information. Press Info/menu button on the
main unit repeatedly to view information through DLS (Dynamic Label Segment),
Ensemble, Program Frequency, Signal Quality, Signal Strength, Bitrate, Codec, Channel
and Date.
FM Mode
Selecting FM Mode
1.
Press DAB/FM button repeatedly to select FM mode.
2.
For initial use, it will start at the beginning of the FM frequency range
(87.50MHz). Otherwise, the last listened FM station will be selected.
3.
To manually change the FM frequency, while FM frequency shows up, press Tune –
or Tune + button to change the frequency by 0.05MHz.
4.
To automatically scan, while FM frequency shows up, press and hold Tune –
or Tune + button for 3 seconds, your radio will skip backwards or forwards
until it reached the next available station.
Scan setting
By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations.
1.
To change the scan settings to stop only at stations with good signal strength,
To Next Page
Loading...
