smith&nephew VERSAJET

Questions and Answers

M
Michael LandryAug 5, 2025
What to do if the motor doesn't run, the switch light is on, and the error light is on in my smith&nephew Medical Equipment?
- D
  Danny BarrettAug 5, 2025
  If the motor of your smith&nephew Medical Equipment does not run, but the switch light is on, and the error light is also on, it indicates an over-current situation. First, try turning off the main power switch, wait for 5 seconds, and then turn the power back on. This may resolve the issue if it was caused by an unknown reason. However, if the over-current situation is due to a plugged high-pressure hose in the handpiece, you will need to discard the handpiece assembly and replace it with a new one.
C
calhounjeffreyAug 10, 2025
How to fix excessive spray from smith&nephew Medical Equipment?
- K
  Katherine RobertsonAug 10, 2025
  Excessive spray from your smith&nephew Medical Equipment can be caused by several factors. It might be due to an obstruction in the evacuation tube caused by grit, a stick, wire, or other foreign material. In this case, remove the handpiece from the surgical field, take your foot off the foot pedal, and remove the obstruction from the instrument tip. Another reason could be a misaligned jet. If this happens, stop using the device and replace the handpiece. Also, check the waste hose to ensure it is draining properly by raising it so that the collector end is the lowest point. Finally, inspect the waste hose for obstructions, kinks, or pinches; remove any obstructions, unkink the hose, or remove any objects causing a pinch.
J
Jonathan MortonAug 14, 2025
What to do if the motor doesn't run, but the switch and pedal lights are on in my smith&nephew VERSAJET Medical Equipment?
- S
  Stephen AlvaradoAug 15, 2025
  If the motor of your smith&nephew Medical Equipment does not run, but the switch light and pedal light are on, ensure that the foot switch is securely attached. If it is already attached, the foot switch may be damaged and needs replacement.
K
Kelly ClarkAug 20, 2025
Why is there no fluidjet in my smith&nephew VERSAJET Medical Equipment handpiece even though the motor is running?
- L
  Latoya JonesAug 20, 2025
  If the motor of your smith&nephew Medical Equipment is turning, but no fluidjet is visible in the handpiece, first ensure that there is a fluid supply by attaching a saline bag or replacing it if it's empty. If the saline bag is not the reason, there may be air in the supply hose. To resolve this, pump fluid on a high setting until the system is purged of all air.
J
Joy JamesAug 26, 2025
How to troubleshoot a smith&nephew VERSAJET when the motor doesn't run and the switch light is off?
- J
  josephcookAug 26, 2025
  If the motor does not run, and the switch light is off on your smith&nephew Medical Equipment, verify that the power cord is securely attached to both the back of the console and the wall outlet. Also, ensure that the power switch is in the 'on' position.
N
Nicholas FlowersAug 30, 2025
What to do if the motor doesn't run, but the switch and door lights are on in my smith&nephew Medical Equipment?
- J
  Jason VasquezAug 30, 2025
  If the motor of your smith&nephew Medical Equipment does not run, but the switch light and door light are on, it means the cartridge clamp is not fully closed. Completely close the cartridge clamp to resolve this issue.