12
4.4 TREATMENT METHOD – STAMP OR GLIDE
There are two recommended methods for treatment - ‘Stamp’ or ‘Glide.’ For whichever method
you choose, the handset must be moved between flashes to ensure the area is treated evenly and
no bits are missed.
Stamp Method
Best for small areas such as the underarm and face. Place the
handset on the skin, press and release the activation button.
Remove from the skin before carefully re-applying to the next
treatment area.
Glide Method
This is best for larger areas such as legs. Place the handset on the skin, press and hold down the
activation button, then glide the handset along the skin between flashes. Try to move the handset
at a steady speed that gives full coverage without overlap or missed areas.
4.5 SWITCHING OFF
When you’ve finished your treatment, SMOOTHSKIN BARE+ should be unplugged from the
electrical outlet. Refer to section 5.3 for details of how best to look after SMOOTHSKIN BARE+.
Treatment
Window
Full Coverage Overlapping Missed Areas
The device needs
to recharge between
flashes. This will take about
half a second.
Make sure not to cover the vents on the device whilst
treating, as this can lead to the device overheating.
SMOOTHSKIN BARE+ is an extremely fast and
powerful device, allowing you to complete a whole
body treatment in under 10 minutes.
5.0 AFTERCARE
5.1 POSSIBLE SIDE EFFECTS
SMOOTHSKIN BARE+ is a powerful device. Some people may experience slight discomfort (e.g.
heat or redness of the skin) during use - this is normal. This type of reaction usually disappears
within 24 hours. Side eects or reactions are usually immediate or appear within 24 hours. If you
are concerned, stop using SMOOTHSKIN BARE+ and visit the SMOOTHSKIN website for support
www.smoothskin.com
Vents
To Next Page
Loading...
