Snap-On CGG8850 - Battery Pack Specifications; Battery Charger Specifications

8
ZCGG8850CE Rev. D (08/20)
Snap-on disclaims liability for the consequences of
using the declared values, instead of values
reflecting the actual exposure determined in an
individual risk assessment in a work place situation
over which we have no control.
Symbology
SYMBOLOGY
REFER TO INSTRUCTION
MANUAL/BOOKLET
WEAR EYE PROTECTION
WEAR HEARING PROTECTION
WEAR RESPIRATORY
PROTECTION
VIBRATION HAZARD
VOLTS
DIRECT CURRENT
n
0
xxx/min NO LOAD SPEED
CE MARK
MET LABORATORIES
PROPERLY RECYCLE BATTERY
DO NOT THROW IN GARBAGE
BC
CALIFORNIA -
TITLE 20 COMPLIANT
Battery Pack
Specifications
CTB185 CTB8187
Type Lithium-Ion Lithium-Ion
Voltage 18 VDC
(3.6 V x 5 cell
pairs)
18 VDC
(3.6 V x 5 cell
pairs)
Weight ~1.5 lbs
(0.68 kg)
~1.5 lbs
(0.68 kg)
Charge Time refer to section Battery Charging
Life
1000 cycles
(1 cycle=1 charge and 1 discharge)
Capacity 5.0 Ah 5.0 Ah
Discharge
Temperature
Range
-4°F(-20°C) to 140°F(60°C)
Battery Charger
Specifications
CTC131/CTCA131/
CTCEU131/CTCJ131
Input 100-240V, 50/60 Hz
Output 5.0 A
Output
USB Power Port
5.0VDC@0.5A
Weight ~2.11 lbs (0.95 kg)
Charging
Temperature Range
(CTB185/CTB8187)
32°F(0°C) to 113°F(45°C)
Application
General Description
The Snap‑on Cordless Grease Gun was exclusively
designed to pump and dispense lubricant using 18V
battery power. Do not exceed the maximum specification
ratings.
Rotary motion of the motor is converted into a
reciprocating motion of the plunger, using a yoke
mechanism. A positive displacement single acting pump
equipped with PCB (Printed Circuit Board) runs the
grease gun.
PCB (Printed Circuit Board)
The motor is protected by the PCB. It shuts off the motor
if the gun runs continuously with maximum pressure.
A warning light on the back side of the handle flashes red
when the motor shuts off.