Snap-On EEDM575D - Record Mode (MAX; MIN)

27
Other Features (continued)
Record Mode (MAX / MIN)
Record mode allows you to record the maximum
and minimum readings measured during a test.
1. Manually select the range for the function and
set the meter up to perform a measurement as
outlined earlier in this manual.
2. Depress the MAX/MIN button and
“ MAX” will
be displayed along with the maximum reading
recorded. Press the MAX/MIN button again
and the display will show MIN and the mini-
mum reading recorded.
3. Press the MAX/MIN button again and MAX
MIN will blink and the EEDM575D will display
the measured value in real time. Steps 2 and 3
can be repeated to read the maximum and
minimum recorded values.
4. If REL was activated and is being used with
MAX/MIN, REL and MAX MIN will blink and
the display will show the REL value instead of
the real time reading.
5. To exit record mode, press and hold the
MAX/MIN button for approximately two sec-
onds and the EEDM575D will beep and return
to normal operation.