Snap-On EEDM575D - Measurement Techniques; Controls and Functions

12
D. MEASUREMENT TECHNIQUES
1. Controls and Functions:
Push Buttons
REL
Activates Relative mode. Press and
hold for 2 seconds to deactivate.
Zero Mode in 110A and 400A at DCA
Funtion.
D-H Holds the reading on the display until
the button is pushed a second time.
R-H Activates manual ranging. Press and
hold for 2 seconds to return to auto
ranging.
MAX MIN Activates record mode. Press to cycle
between maximum and minimum
recorded reading. Press and hold for 2
seconds to return to normal mode.
P-H Activates peak hold mode. Used to
capture in-rush current.
NCV Activates the non-contact voltage
detection feature. Press and hold while
holding the jaw close to electrical
wires.