Snap-On EEDM575D - Maintenance; Battery and Fuse Replacement; Cleaning the EEDM575 D

36
H. Maintenance
1. Battery / Fuse Replacement: The EEDM575D will
display a battery symbol when the internal 9 Volt
battery needs replacement. If DC microamps does
not operate correctly the 0.5A / 600V fuse needs
to be replaced. The battery or fuse is replaced as
follows:
a. Disconnect and remove all test leads
from live circuits and from the EEDM575D.
b. Loosen the screw from the back of the
EEDM575D battery / fuse cover.
c. Remove the battery / fuse compartment
cover.
d. Remove old battery or fuse and replace with
new battery or fuse. Observe the correct
polarity on the battery. Only install the correct
value fuse (0.5A/600V). Failure to do so can
result in instrument damage.
e. Reassemble the instrument in reverse order
from above.
2. Cleaning your EEDM575D:
Use a mild detergent and slightly damp cloth to
clean the surfaces of the EEDM575D.