19
EEWB331B
To make the corrections,
— Select an adhesive weight of the indicated size and
adjust it to the wheel radius by bending.
— If necessary, index the wheel precisely into the
correction position for the left plane. When the
correction position is reached, all the rotation
indicators for the left plane light up.
— Press the pedal of the main shaft lock to hold the
wheel in this position.
• Clean the fitting position before attaching the
adhesive weights.
• Fit the balancing weight and firmly press the
adhesive weight onto the rim.
• Fit the second adhesive weight in the same manner.
Note: With STATIC weight modes, always apply
the weight at the rim center line. If not
possible, split the weights evenly and
apply on another surface of the rim
(symmetrical to the rim center line).
To Next Page
Loading...
