Snap-On EEWB331B - Page 27

27
EEWB331B
• Readjust the tire on the rim so that the reference
m
ark made is aligned with the valve (use tire
changer).
• Clamp the wheel on the balancer and readjust it until
the valve is exactly perpendicular to and above the
main shaft.
• Press the ENTER key (1) to acquire the valve
position.
The OP.6 reading appears (Fig. 34).
• Spin the wheel (ST
ART).
After the measuring run four readings are possible:
II - OP.7
Proceed with the OP program. It is recommended that
the tire be turned over on the rim.
OP.7 - II
Proceed with the OP program. It is recommended to
shift the tire on the rim (manual rotation).
H0
Optimum condition has been achieved and cannot be
improved.
H2
Silent running cannot be improved.
• Press STOP (5) to exit.
1
2
3
4
5
Figure 32
Figure 34
Figure 37