Snap-on EEWH331A
EN 5
INSTRUCTIONS: Safety Label Meanings
IMPORTANT!! SAVE THESE INSTRUCTIONS
Overinfl ated tires or tires mounted on the wrong sized rims can explode producing hazardous fl
ying debris.
· Read and understand the operation instructions before using this tire changer.
· Never mount tire on rim with di" erent sized diameter.
· Never exceed maximum in# ation pressure listed on tire sidewall.
· Always use safety restraint arm to hold wheel in place while in# ating.
· Always use attached air hose to in# ate tires.
Exploding tires can cause death or serious injury.
Risk of electrical shock.
· Do
not operate equipment with a damaged power cord or if the equipment has been dropped or
damaged,
until it has been examined by a quali$ ed service person.
· If an extension cord is necessary, a cord with a current rating equal to or greater than that of the equipment
should be used. Cords rated for less current than the equipment can overheat.
· Unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from the outlet.
Grasp plug and pull to disconnect.
· Do not expose the equipment to rain. Do not use on wet surfaces.
· Plug unit into correct power supply.
· Do not remove or bypass grounding pin.
Contact with high voltages can cause death or serious injury.
Risk of electrical shock. High voltages are present within the unit.
· There are no user serviceable items within the unit.
· Service on the unit must be performed by quali$
ed personnel.
· Do not open any part of the unit other than noted and allowed areas.
· Turn power switch o" and unplug the unit before servicing.
Contact with high voltages can cause death or serious injury.
Risk of crushing.
· Become familiar with all controls before proceeding with operation.
· Stand away from the bead breaker arm when in operation.
· Apply air to breaker in bursts if necessary to control arm depth.
· Don’t allow to approach extraneous people to the service.
Contact with moving parts could cause injury.
Risk of pinching or crushing hands and fi
ngers.
· Keep hands and $ ngers clear of rim edge during demounting and mounting process.
· Keep hands and $ ngers clear of mount/demount head during operation.
· Keep hands and other body parts away from moving surfaces.
· Do not use tools other than those supplied with tire changer.
· Do not use unapproved accessories
· Do not bypass any safety features.
· Use proper tire lubricant to prevent tire binding.
Contact with moving parts could cause injury.
Risk of eye injury
. Debris, dirt, and fl
uids may drop from wheels.
· Remove any debris from tire tread and wheel surfaces.
· Remove excess tire lubricant before in# ating.
· Knock o" any loose debris. Clean surfaces as needed to avoid any materials from falling.
· Wear approved safety glasses during mount and demount procedures.
Debris, dirt, and fl uids projection can cause serious eye injury.
Risk of injury
. Tools may break or slip if improperly used or maintained.
· Use the correct tool for the task.
· Frequently inspect, clean, and lubricate (if recommended) all tools.
· Follow recommended procedures when performing wheel services.
Tools that break or slip can cause injury.
Collision and dragging hazard:
· do not rotate the turntable without wheel on board
· do not approach the turntable plate while it is moving
· pay attention to the jaws when these stick out of the turntable plate
· do not place any protruding objects on the turntable plate
· do not place any protruding objects near the turntable plate
Contact with moving parts could cause injury
.
To Next Page
Loading...
