Rev 07272020 Page 6 of 15
Quick Start Guide
• Keep fridge upright for 24 to 48 hours before plugging it in.
• Remove all outside packing material. Do not use a knife to cut into
materials as it may scratch the surfaces.
• Using a two-person team, tilt beverage dispenser at 45° angle to access
the bottom. Install four (4) feet, level the unit by adjusting the height of
the feet. Never lay unit on its back while installing the feet. This will
damage the unit.
• Protect flooring by placing unit onto tray if needed.
• Assemble/install the Dispensing Button; see instruction on following page.
• Plug unit directly into wall outlet do not use extension cord.
• Set temperature control to Default 36° Fahrenheit listed on the dial.
• Run unit empty for 1 hour at default temperature setting
• Fill unit with product. Only standard 12oz cans (DO NOT use Skinny cans).
• After filled allow cans to chill and adjust temperature setting according to
personal preference.
To Next Page
Loading...