Rev 07272020 Page 8 of 15
Temperature Control
• The temperature control is located inside the beverage dispenser compartment (see page 3). Before leaving the
factory, beverage dispenser has been preset to default, leave at this setting during start up.
• Turn the knob clockwise to lower the temperature in the beverage dispenser and turn it counter-clockwise to raise
the temperature. Please turn the knob to the extreme cold position if you need low temperature, but do not force the
beverage dispenser to work in such mode for a long time.
• Turn the knob to “STOP” position to stop the beverage dispenser (no cooling provided in Stop mode).
Loading the Machine
• The Can Shelves are designed for standard U.S. 12 oz size cans (DO NOT use Skinny cans).
• After the unit has been running for 1 hour, place up to 54 cans maximum, load cans into machine alternating front to
back placements.
• Do not add cans past the fill point line.
To Next Page
Loading...