Rev 07272020 Page 9 of 15
Dispensing
• Press the Push Button to dispense cans. Do Not kick or punch the button to dispense. This will break the unit.
• If cans do not dispense, open the door and check the alignment of the cans in the rail. Straighten any tilted cans.
• Visually inspect shelves to spot where the jam is. Tap the shelf gently to attempt to realign cans into place.
• If jam persists unscrew the top bar to remove shelves to the place the jam has occurred. Straighten cans. Re-insert
shelves making sure they lock in place. Place screws back onto locking bar to secure the shelves.
• Reload unit
Defrost and Condensation/Water
• This unit is designed for indoor use only. Use in another environment may cause condensate/water to expel through
the feet of the unit. Protect flooring by placing unit onto a tray (if needed).
• There may be frost on internal backside of the beverage dispenser when it is working. This frost will thaw after the
compressor stops running. The water will flow to the evaporating container through the drain groove. Please make
sure there is no blockage in the drain hole.
• Please shut down the beverage dispenser to defrost if there is too much frost inside the beverage dispenser.
• Notes: Don’t use hard or sharp tools to remove the frost. The cooling system may be damaged by such tools.
• The condensate water will be evaporated automatically. If the humidity in the air is too high for water to evaporate,
open the compressor protective cover on the back of the compressor bin and pour out the water in the evaporation
pan: (See picture).
To Next Page
Loading...