Snap-On TECHANGLE STEEL ATECH4RS600

10
Note: To select a stored PSET or manual target torque or angle mode, repeatedly press ENTER  
buttonuntil desired PSET or manual mode is displayed.
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS U button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP S  /DOWN T  buttons then press ENTER   button.
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing
UP S  /DOWN T buttons. Once desired target torque or angle value has been set, press
ENTER   button.
5. MAXIMUM TORQUE or ANGLE screen is displayed next. Value can be changed by pressing
UP S  /DOWN T  buttons. Once desired target torque or angle value has been set, press
ENTER   button.
6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP S  /DOWN T 
buttons. Once desired batch count value has been set, press ENTER   button.
7. PSET target screen is displayed labeled with same PSET number.
Note: Pressing ENTER   button while EXIT menu selection is highlighted will exit without editing
PSET.
BATCH COUNT
0
ENTER
button
UP/DOWN buttons
CHANGE PRESET
DELETE
EDIT
EXIT
PSET 02 00
92°
UNIT
button
held
Preset Angle Screen
UP/DOWN buttons
ENTER button
PSET 02 00
90°
Preset Angle Screen
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER
button
UP/DOWN buttons
MINIMUM ANGLE
92°
MAXIMUM ANGLE
94°
UP/DOWN buttons
ENTER
button