Snap-On TECHANGLE STEEL ATECH4RS600

11
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS U button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE menu selection using UP S  /DOWN T  buttons and press ENTER   button.
4. Target screen is displayed and deleted PSET is no longer available for selection.
Note: Pressing ENTER   button while EXIT menu selection is highlighted will exit without deleting
PSET.
Note: When a PSET is deleted, all other stored PSET’s will retain their original PSET numbers. When a
new PSET is entered, it will be assigned first available PSET number in sequence.
00
100.0
FT-LB
CHANGE PRESET
DELETE
EDIT
EXIT
UNIT
button
held
Target Screen
UP/DOWN buttons
ENTER button
PSET 02 00
92°
Preset Angle Screen
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER button