32 SnapperPro.com
Not all greases are compatible. Red grease (p/n 5022285)
is recommended. Automotive type, high temperature, lithium
grease may be used when this is not available.
Oil:
• ground speed control lever pivots & linkages
• parking brake shaft pivots
• seat plate pivots
• deck lift pivot points
• discharge chute hinge
Generally, all moving metal parts should be oiled where
contact is made with other parts. Keep oil and grease off belts
and pulleys. Remember to wipe fittings and surfaces clean
both before and after lubrication.
29
30
31
Lubricate the Front Casters
Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 32) screwed into the
caster and install a 1/4-28 grease fitting.
32
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the 1/4-28
bolt.
4. Repeat the process for the other side of the machine.
Servicing the Mower Blades
Removing the Mower Blades
CAUTION
Laceration hazard
Mower blades are sharp.
Always wear gloves when handling, or working near, mower
blades.
1. Use a block of wood to prevent the mower blade from
turning as shown in Figure 33.
To Next Page
Loading...
