Snapper 3 Series Installation Instructions & Operator's Guide

IMPORTANT SAFETY INSTRUCTIONS
WARNING: Failure to comply with the following instructions may result in serious injury to the operator or
other persons. The owner of the snow thrower must understand these instructions and, furthermore, must
allow only persons who understand these instructions to operate snow thrower. Each person operating the
snow thrower must be of sound mind and body and must not be under the influence of any substance which
might impair vision, dexterity, or judgment, if you have any questions pertaining to your snow thrower which
your dealer cannot answer to your satisfaction, call or write the Customer Service Department at SNAPPER,
McDonough, Georgia 30253. Phone: (404) 954-2500.
PROTECTION FOR CHILDREN OPERATIONAL PRECAUTIONS
1. DO NOT allow children in the area when snow
thrower is being operated.
2. DO NOT allow pre-teenage children to operate
snow thrower.
3. DO NOT allow irresponsible teenagers to
operate the machine - allow teenagers only if
exhibiting mature judgment and then only after
being thoroughly instructed and under the close
supervision of an experienced operator.
PREPARATION
1. Read this manual, get to know where all
controls are located and practice how to use
them before starting for the first time, and at the
beginning of each season. Pay attention to
Warning and Instructional Decals on engine and
snow thrower.
2. Wear adequate winter clothing including boots
which will give you maximum footing on
slippery surfaces. Exercise CAUTION to avoid
slipping or falling.
3. Before the first snow fall, check the area to be
cleared and remove all objects such as
doormats, sticks, toys, wires, rocks, etc., which
could be hurled or jam the snow thrower.
4. Survey the area to be cleared beforehand and
plan where snow is to be blown. Be prepared to
release auger/impeller clutch or to change
discharge chute direction quickly to discharge
away from windows, cars, buildings and
doorways to avoid property damage or personal
injury from hurled objects.
5. Handle fuel with care. Store only in an approved
gasoline container. Move the machine outdoors
where fumes can be safely dissipated before
filling tank. Never add fuel to a running engine
or hot engine. Replace gasoline cap securely &
wipe up spilled fuel.
OPERATIONAL PRECAUTIONS
1. Before starting, make visual check to make sure
auger/impeller housing is clear and all guards
and shields are in place and tight.
2. Warn everyone in advance to stay clear of area
but keep especially watchful for children and
pets darting into area while operating.
3. Start engine only where exhaust fumes will be
safely dissipated, allow a brief warm-up period,
practice operation of controls outside before
putting the machine to work.
4. Should the auger/impeller become clogged,
release the auger/impeller clutch control and, as
an additional precaution, stop the engine before
attempting to unciog the auger/impeller or
discharge chute.
5. After striking a foreign object, stop the engine
(motor), remove the wire from spark plug,
thoroughly inspect the snow thrower for any
damage, and repair the damage before
restarting and operating the snow thrower.
6. Stop the engine if the machine starts to vibrate
excessively as this normally indicates
mechanical problems. Disconnect the spark
plug wire to prevent unintentional starting
before servicing or repairing the machine.
7. DO NOT clear snow across the face of slopes.
Exercise extreme caution when changing
direction on slopes. DO NOT attempt to clear
steep slopes.
8. Stop the engine and remove the key whenever
you leave the unit unattended to eliminate the
possibility of children or untrained adults from
attempting to operate the machine.
9. Release clutch control and make sure
auger/impeller has stopped before adjusting
deflector, or placing hands near auger/impeller.
10. DO NOT use snow thrower on surfaces above
ground level, such as, a roof of a building.
11. Exercise extreme caution when operating on or
crossing gravel drives, walks, or roads. Stay
alert for hidden hazards or traffic.
12. DO NOT overload the machine capacity by
attempting to clear snow at too fast a rate.
13. Never operate the machine at high transport
speeds on slippery surfaces. Look behind and
use care when backing.
14. Disengage power to the auger/impeller when
snow thrower is transported or not in use.
15. Use only attachments and accessories approved
by the manufacturer of the snow thrower (such
as wheels weights, counterweights, cabs and
the like).
16. Never operate the snow thrower without good
visibility or light. Always be sure of your
footing, and keep a firm hold on the handles.
Walk; never run.

Snapper 3 Series Specifications

General

Brand	Snapper
Model	3 Series
Category	Snow Blower
Language	English