EasyManua.ls Logo

Snapper 360Z Zero Turn Rider

Snapper 360Z Zero Turn Rider
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Not for Reproduction
Maintenance Chart
TRACTOR AND MOWER
Every 8 Hours or Daily
Check safety interlock system
Clean debris o tractor and mower deck
Clean debris from engine compartment
Every 25 Hours or Annually *
Check mower blade stopping time
Check tractor and mower for loose hardware
Check tire pressure
Every 50 Hours or Annually *
Check tractor brakes
Clean battery and cables
See Dealer Annually to
Lubricate tractor and mower
Check mower blades **
* Whichever comes rst
** Check blades more often in regions with sandy soils or
high dust conditions.
ENGINE
First 5 Hours
Change engine oil
Every 8 Hours or Daily
Check engine oil level
Every 25 Hours or Annually *
Clean engine air lter and pre-cleaner **
Every 50 Hours or Annually *
Change engine oil
Replace oil lter
Annually
Replace air lter
Replace pre-cleaner
See Dealer Annually to
Inspect muer and spark arrester
Replace spark plug
Replace fuel lter
Clean engine air cooling system
* Whichever comes rst
** Clean more often in dusty conditions or when airborne
debris is present.
Emissions Control
Maintenance, replacement, or repair of the emissions control
devices and systems may be performed by any non-road en-
gine repair establishment or individual. However, to obtain “no
charge” emissions control service, the work must be performed
by a factory authorized dealer. See the Emissions Warranty.
Maintenance
WARNING
Unintentional sparking can result in re or electric
shock.
Unintentional start-up can result in entanglement,
traumatic amputation, or laceration.
Before performing adjustments or repairs:
Disconnect the spark plug wire and keep it away from
the spark plug.
Disconnect battery at negative terminal (only engines
with electric start).
Use only correct tools.
Do not tamper with governor spring, links, or other
parts to increase engine speed.
Replacement parts must be of the same design and in-
stalled in the same position as the original parts. Other
parts may not perform as well, may damage the unit,
and may result in injury.
Do not strike the ywheel with a hammer or hard object
because the ywheel may shatter during operation.
22

Table of Contents

Related product manuals