31
ENGINE *
Briggs & Stratton
Model Intek
TM
Series
Displacement 44.18 cu in. (724 cc)
Model Professional Series
TM
Displacement 44.18 cu in. (724 cc)
All Engines
Oil Capacity 64 oz (1,9 L)
Spark Plug Gap 0.030 in. (0,76 mm)
Spark Plug Torque 180 in-lbs (20 Nm)
CHASSIS
Fuel Tank Capacity 3 gal (11,4 L)
Front Wheels Ination Pressure: 22 psi (1,52 bar)
Rear Wheels Ination Pressure: 12 psi (0,83 bar)
TRANSMISSION
Type Hydro-Gear
®
EZT
®
Type Hydro-Gear
®
ZT-2800
®
MOWER
Width of Cut 42” (107 cm)
44” (112 cm)
46” (117 cm)
48” (122 cm)
52” (132 cm)
Cutting Height 1.5” - 4.5” (3,8 - 11,7 cm)
The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995.
Torque values are derived at 2600 RPM for those engines with “rpm” called out on the label and 3060 RPM for all others;
horsepower values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.
COM. Net power values are taken with exhaust and air cleaner installed whereas gross power values are collected
without these attachments. Actual gross engine power will be higher than net engine power and is aected by, among
other things, ambient operating conditions and engine-to-engine variability. Given the wide array of products on which
engines are placed, the gasoline engine may not develop the rated gross power when used in a given piece of power
equipment. This dierence is due to a variety of factors including, but not limited to, the variety of engine components
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions
(temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs &
Stratton may substitute an engine of higher rated power for this engine.
Power Rating *
Parts and Accessories
See an Authorized Service Dealer.
* NOTE: The engine information contained in this manual applies to Briggs & Stratton engines only. For information regard-
ing non-Briggs engines, refer to the engine manual supplied with your unit.
To Next Page
Loading...
