Snapper 4220 Series User Manual

Section III - MAINTENANCE
3.10 SKID SHOE ADJUSTMENT
The skid shoes should be lowered to raise the
blower housing to clear gravelled or rough surfaces.
If necessary .adjust until almost even with the edges
of the housing to allow clearing down to smooth
paved surfaces. Note that the skid shoes can be
installed upside down to track better over icy or
hard-packed surfaces. To adjust the skid shoes,
block under the lower edge of the blower housing.
Loosen the retaining nuts and slide shoe up or down
to desired height. Retighten the nuts. Set both skid
shoes in the same position. See Figure 3.7.
FIGURE 3.7
3.11 SERVICE ASSISTANCE
Contact your SNAPPER Dealer for replacement
parts or for assistance when service is needed to
keep your SNOW THROWER in top condition. To
obtain the correct parts or advice for your particular
model, always report the model and serial numbers
as found on the nameplate attached to the frame.
For engine parts and service, contact the engine
manufacturer’s dealer in your area. Complete
PARTS and SERVICE (Overhaul and Repair)
Manuals are available for your SNOW THROWER
at nominal cost. Order these from your SNAPPER
Dealer.
Service Notes

Snapper 4220 Series Specifications

General

Brand	Snapper
Model	4220 Series
Category	Snow Blower
Language	English