3
ENGINE:
Brand Briggs & Stratton
Model Series 525 Snow Series
Gross Torque* 5.25 TP
Type 4-Cycle
Displacement 9.02 cu in.
Starting System 110V Electric, Recoil
Oil Capacity 20 oz (0,59 liters)
Engine Oil Synthetic 5W30
Fuel Tank Volume 2 qts (1,90 liters)
Spark Plug Gap 0.030 in. (0,76 mm)
Resistor Spark Plug 802592
Long Life Platinium Spark Plug 5062
AUGER:
Clearing Width 21 in. (53,3 cm)
Intake Height 10.25 in. (16 cm)
Auger Diameter 7 in. (18 cm)
CHUTE:
Chute Defl ector Manual
Chute Rotation Manual
DRIVE SYSTEM:
Drive Type Auger Propelled
Tire Size 7 x 1.5 in. (17.78 x 3.81 cm)
*Ignition System This spark plug ignition system complies with Canadian standard ICES-002.
Engine Power Rating Information
*The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers)
code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in ac-
cordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600
RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-
to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues
applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power
equipment (actual “on-site” or net power). This difference is due to a variety of factors including, but not limited to, accessories
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (tem-
perature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton
may substitute an engine of higher rated power for this Series engine.
Specifi cations
28
To Next Page
Loading...
