EasyManuals Logo

Snapper CDM-8915 User Manual

Snapper CDM-8915
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
C
H
1
11
C
H
1
10
BATTERY USAGE BATTERY USAGE
BATTERY INSTALLATION
1
u
Place the battery on the back of the handset
and slide into place.
v
Push the battery down
until it locks into place.
BATTERY REMOVAL
1
u
Pull down the release latch, lift up the
battery and
v
remove the battery from the
handset.
If the battery is not correctly placed in the compartment, the
handset will not turn on and/or the battery may detach during use.
When you charge the battery with the phone power off, you
will see a charging status screen. You cannot operate the
phone until it is powered on.
The battery is not charged at the time of purchase.
Fully charge the battery before use.
It is more efficient to charge the battery with the handset
powered off.
The battery must be connected to the phone in order to charge it.
Battery operating time gradually decreases over time.
If the battery fails to perform normally, you may need to replace
the battery.
1
Plug the AC Charger into a standard outlet.
2
Plug the other end of the AC Charger into the
bottom of your phone. The battery must be
installed onto the phone.
BATTERY CHARGING
POWER CONNECTION

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snapper CDM-8915 and is the answer not in the manual?

Snapper CDM-8915 Specifications

General IconGeneral
BrandSnapper
ModelCDM-8915
CategoryCell Phone
LanguageEnglish